krane: restore CONFIG_USB dropped by the R35 defconfig edit; rotate 270

The R35 rotation edit used PUT 77.=77 against a stale line number and
overwrote CONFIG_USB=y with a duplicate VIDEO block, leaving the USB
menuconfig unset: no USB controller, no usb command, no keyboard.
Restore CONFIG_USB=y (deduplicate VIDEO) and verify the full USB set
in .config after the defconfig re-run.

Also flip the console rotation from 1 (90 degrees clockwise) to 3
(270 degrees clockwise): rot=1 read upside down on the device with
the keyboard attached.

configs/mt8183_kukui_krane_defconfig

@@ -74,9 +74,8 @@ CONFIG_VIDEO_MT8183_SCANOUT=y
 CONFIG_MMC_MTK=y
 CONFIG_PHY=y
 CONFIG_PHY_MTK_TPHY=y
-CONFIG_VIDEO=y
-CONFIG_VIDEO_MT8183_SCANOUT=y
 CONFIG_CONSOLE_ROTATION=y
+CONFIG_USB=y
 CONFIG_DM_USB=y
 CONFIG_USB_XHCI_HCD=y
 CONFIG_USB_XHCI_MTK=y

drivers/video/mt8183_scanout.c

@@ -349,12 +349,14 @@ static int mt8183_scanout_probe(struct udevice *dev)
 	 * The BOE TV101WUM-NL6 panel is mounted rotated 270 degrees in
 	 * the krane chassis (see the panel node's "rotation" property in
 	 * the upstream DT). The keyboard-covered landscape orientation
-	 * therefore needs the console rotated by 90 degrees clockwise
-	 * relative to the native scanout; the uclass then binds the
-	 * rotated vidconsole1 text driver, which swaps the console
-	 * geometry (240x75 columns/rows on this panel).
+	 * therefore needs the console rotated; the uclass then binds the
+	 * rotated vidconsole3 text driver, which writes glyphs rotated
+	 * by 270 degrees clockwise into the native 1200x1920 portrait
+	 * scanout and swaps the console geometry (240x75 columns/rows
+	 * on this panel). rot=1 (90 degrees) was tried first and read
+	 * upside down on the device (R35).
 	 */
-	uc_priv->rot = 1;
+	uc_priv->rot = 3;
 
 	printf("Video: MT8183 scanout %dx%d@32bpp at %llx\n",
 	       uc_priv->xsize, uc_priv->ysize, (unsigned long long)plat->base);