Boards based on the Allwinner D1/T113-s3, such as the
NetCube Systems Nagami, can expose a third I2C controller
on PG10/PG11. However, the sun20i_d1 pinctrl function table
lacked an entry for this mux.
Add the "i2c3" function with mux value 3 on PG10/PG11, allowing device
trees to enable the I2C3 controller.
Signed-off-by: Lukas Schmid <lukas.schmid@netcube.li>
Reviewed-by: Andre Przywara <andre.przywara@arm.com>
The T113-s4 SoC is using the same die as the T113-s3, but comes with
256MiB of co-packaged DRAM. Besides the doubled size, the DRAM chip
seems to be connected slightly differently, which requires to use a
different pin remapping.
Extend the DRAM initialisation code to add support for the T113-S4 aka
T113M4020DC0 by checking the SoC's CHIPID, which is stored in the first
word of the SID efuses.
Signed-off-by: Lukas Schmid <lukas.schmid@netcube.li>
Tested-by: John Watts <contact@jookia.org>
Reviewed-by: John Watts <contact@jookia.org>
Reviewed-by: Andre Przywara <andre.przywara@arm.com>
Signed-off-by: Andre Przywara <andre.przywara@arm.com>
NetCube Systems Kumquat is a board based on the Allwinner V3s SoC,
including:
- 64MB DDR2 included in SoC
- 10/100 Mbps Ethernet
- USB-C DRD
- Audio Codec
- Isolated CAN-FD
- ESP32 over SDIO
- 8MB SPI-NOR Flash for bootloader
- I2C EEPROM for MAC addresses
- SDIO Connector for eMMC or SD-Card
- 8x 12/24V IOs, 4x normally open relays
- DS3232 RTC with Battery Backup
- QWIIC connectors for external I2C devices
Signed-off-by: Lukas Schmid <lukas.schmid@netcube.li>
Reviewed-by: Andre Przywara <andre.przywara@arm.com>
Signed-off-by: Andre Przywara <andre.przywara@arm.com>
Lukas SchmidandAndre Przywara